Smoke Sensitivity Inspections

 

Request for a Fire Alarm Area Smoke Detector or Duct Smoke Detector Sensitivity/Calibration Inspection, please complete the following, and press "submit" at the bottom

If you require immeadiate assistance, Please call EDS Inc. at 1-888-611-1741

Your Name
Your Company
Street Address
City
State
Zip Code
Phone
Facsimile
Email

 
Service Location
Street Address
City
State
Zip Code
Service location Phone
Contact Person

 

Additional Comments or Information Here

Email us !!


EDS Inc. shall perform sensitivity testing on all area smoke and duct smoke detectors.
Smoke or duct smoke detectors found outside the listed marked sensitivity range shall be cleaned and recalibrated and or replaced.

Sensitivity certification reports shall be provided to the facility upon completion.

To get started, Please fill out the following and press "Submit".

NFPA 72 7-3.2.1 states: "Detector sensitivity shall be checked within 1 year after installation and every alternate year thereafter. After the second required calibration test, if sensitivity tests indicate that the detector has remained within its listed and marked sensitivity range (or 4 percent obscuration light gray smoke. if not marked), the lenght of time between calibration tests shall be permitted to be extended to a maximum of 5 years. If the frequency is extented, records of detector cause nuisance alarms and subsequent trends of these alarms shall be maintained. In zones or in areas where nuisance alarms show any increase over the previous year, calibration tests shall be performed."